DESCRIPTION
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the
SmartSurge
.
3. Plug the
SmartSurge
unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the
SmartSurge
where monitoring lights
can be observed.
unit
Installation of SmartSurge
Installation for Protection for Telephone Line
Installation for Protection for Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "OUT"
on the
SmartSurge
.
2. Plug the provided telephone cable to the RJ11 jack "IN" on the
SmartSurge
.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
CAUTION
: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
Telephone Line Protection clamping voltage 250-350 vdc.
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Power Cord
Power Cord
IN
IN
OUT
OUT
Phone Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
Use this user's guide for the following products:
Modem & Data Protection (model dependent)
Protection is extended to your phone and network lines with the addition of RJ11 and RJ45 jacks
on the
SmartSurge
unit, creating ideal protection for Fax/Internet/Network users. Power
surges can pass to the connected equipment through phones lines and network cables.
CAUTION
CAUTION
CAUTION
CAUTION
• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the
SmartSurge
into a three pronged grounded outlet. This unit is not to be used
with any type of ground “lift” or pin eliminator.
• Do not open the
SmartSurge
unit, there are no serviceable parts inside. Opening the unit
will void your warranty.
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
Risk of Electric Shock. Do not plug into another relocatable power tap.
FEATURES
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at support@smartpowersystems.com
MODEL /
PART NUMBER
120V/15A, one 5-15R outlet
120V/15A, one 5-15R outlet, RJ11
120V/15A, one 5-15R outlet, RJ45
120V/15A, one 5-15R outlet, RJ11 + RJ45
SS15
SS15-T
SS15-N
SS15-TN
The green light confirms power exists
at the output receptacle.
GREEN LIGHT
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"OUT" on the
SmartSurge
.
2. Plug the provided CAT5 cable to the RJ45 jack "IN" on the
SmartSurge
.
3. Plug the other end of the CAT5 cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the
SmartSurge
where monitoring lights can be observed.
IMPORTANT: The
is designed to be compatible with a GFCI (Ground Fault
Circuit Interrupter), however, during plug in the GFCI might trip. Press the reset button to
restart the circuit.
SmartSurge
(Phone + Network Protection)
(Phone Protection)
(Network Protection)
