4.4 Installation of the Gear Motors
1) Choose the correct dimensioins of the motors and position to be installed.
2) Check if the mounting surface the brackets to be installed is smooth, vertical and rigid.
3) Arrange the cable conduit for power supply cable of the motors.
4) In order to obtain the optimal supporting from the rear plate, please assemble two post brackes
and one rear metal plast according to below photo
5) Loosen the two screws and remove the back cover of the motor as shown in photo
6) Place the leaves in the closed position.
Figure 18
Figure 19
Figure20
7) Refer to the distance of “B” in figure 17, place the rear plate in the coorect position on the
mounting surface. Inspect if the distance is proper as shown in Figure 23 i.e. the position the front
plate of the motor to be installed.
8) Place two post brackets on the surface to be installed and mark the drilling points, then drill
minimum diameter of 8mm holes by four on the mounting surface to be installed and fasten up the
brackets with screws and washers
9) Please make sure the front plate is completely installed horizontally.
Figure 21
