10) Refer to Figure 23, the distance between front plate of the motor and rear plated is 798mm,
the difference in height is 22.5mm
11) Clamp and fix the motor front plate on the door temporarily
12) Lift up the motor and insert the screws into the front plate.
13) Open the gear motor cover and release the screws, then take out the bolt as below Figure 25.
Lift the motor overhead and push the gate to the end until the screw holes of the motor end
matches the holes on the rear plate as shown in Figure 25.1 and fasten the motor to the rear plate
with bolt and screw as shown in Figure 25.2
