Figure 25
Figure 25.1
Figure 25.2
14) Fasten the nut tightly and loosen if for half round for motor supporting in rotating
15) Fasten the motor front end to the front plate with the bolt (A) and nut (B) tightly. Fully tighten
the screw.
16) Connect the motor power cable as shown in Figure 27
17) Close the gear motor cover by tightening the two screws as shown in Figure 28
Figure 27
Figure 28
18) Gear Motor Release
A. Turn the round plate on the release part to “OPEN” position, See Figure 29
B. Push out the release part to the end. See Figure 30
C. Use the release key to turn the pin ani-clockwise to the end. See Figure 31
