SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2014
36
Field Name
Description
Statically Configure- Select this option to manually configure a static IPv6 prefix.
Enable MLD Snooping
(Optional)
Multicast Listener Discovery (MLD) snooping manages the IPV6 multicast traffic.
Standard Mode: Multicast traffic will flood to all bridge ports when no client subscribes to a multicast
group – even if IGMP snooping is enabled.
Blocking Mode: The multicast data traffic will be blocked and not flood to all bridge ports when there are
no client subscriptions to any multicast group.
Ethernet Config
Ethernet Port Configuration
Set the speed and duplex for each of the Ethernet ports.
After Selecting
Advanced Setup -> Ethernet Config
from the left navigation bar, make your selection from the Configure drop-down menu for
each of the four Ethernet ports on your SmartRG gateway.
Select from Auto, 100 Full, 100 Half, 10 Full or 10 half. These options represent 100 megabit or 10 megabit using half or full duplex transmission
protocols. Make a manual selection from one of the latter four options when you have a specific device with a known limited transmission speed
capability. Simply choose Auto and your SmartRG gateway will automatically select an appropriate setting based on Ethernet auto negotiation
with the NIC of the LAN host.
Model-specific variants:
l
SR510, SR552n, SR500n The fourth port will be described in this screen as eth3/LAN1 and the ports are listed in reverse order. eth4/WAN
interface is also present on these models.
l
SR552n v2.5.0.6 and later has and additional selection available of 1000 Full for all Ethernet interfaces (shown below).
l
SR505n v2.5.0.x and later has and additional selection available of 1000 Full for the LAN1/WAN port.
Click
Apply/Save
to commit your changes.