Marine Revolution
Smartwave SW4800 Owner’s Manual
Page 11
Your boat is UV stabilized and uses only stainless steel hardware, so it will stand up well to the
elements for many years. To maximize the life of your boat we recommend the following:
•
Protect your boat with a storage cover.
•
If your boat will remain unused for long periods, store it indoors if possible.
•
If you keep your boat in a windy area, tie it down.
•
Store the boat with the engine in the running position.
•
Ensure your boat is stored in a position that provides adequate support for the hull. Failure to
do so may result in distortion or indentations.
•
Consult your engine owner’s manual for specific storage and winterising information.
Warranty
Please refer to the warranty card contained within your owners pack for warranty details and
registration information
Trouble shooting
Engine Failure
The main cause of engine failure is likely to be blocked filters;
A blocked fuel filter will reduce power until the engine stops. Change the filter and restart the engine.
If dirty fuel is the culprit, several changes may be required.
A blocked salt water inlet filter will cause rapid overheating, indicated by increased steam from the
exhaust, and eventual seizure. Check the filters for blockage and clear as necessary. Also check pump
is functioning and for leaks in the system.
Refer to your engine owner manual for specific trouble shooting information.
Electrical system failure
Your electrical system is fitted with individually fused circuits.
In the event of electrical failure check the battery connections and battery condition in the first
instance.
If the fault is with the switched instruments, please remove and inspect the individual circuit fuses.
If no evidence of a fuse fault can be found please consult Marine Revolution for further information.
Your engine contains system fuses for the various components. Please refer to the owners’ manual for
further information.
Reduced Power/Revs
Your engine is fitted with safety devices to minimize damage if it overheats or is low on oil. Please
refer to the manual for specific information of the various protection functions
