STEP 4: LED Guide
See the table below for an explanation of the LED status changes on the back
of the recorder.
No.
BLUE LED
RED LED
Meaning
1
Blink every half second
OFF
Event Recording
2
Blink every 4 Seconds
OFF
Continuous Recording
3
SOLID
OFF
Pre-Recording
(Awaiting Triggers)
4
OFF
Blink every half second
Card Fault
5
SOLID
SOLID
System Booting Up
6
Blink every half second
Blink every half second
Unit Fault
7
SOLID
OFF
SD Card Removal
in Safe Mode
8
OFF
OFF
No Power
Red LED
Blue LED
5
Disconnect the power to the unit, wait until all LEDs are off and then remove
the card.
Use SAFE MODE. To enter safe mode whilst the unit is powered and in recording
mode, press the “SD Card Format” (Blue) button for 3 seconds until the unit beeps
to acknowledge it is in safe mode, then remove the SD card.
www.smartwitness.com
SAFE SD CARD REMOVAL
To remove the SD card either:
