www.smartwitness.com
5. Final Steps
After installation of the SVC1080-LCS into the vehicle, you can turn on vehicle ignition and the
camera will power on. There will be a sequence of BLUE/RED LED lights cycling during boot
process.
Once boot up is complete. There will be a solid blue light. This means proper
operation and recording. If a red led comes on after bootup, there is an error and you
should contact your supplier or SmartWitness.
Please refer to troubleshooting section for
more detailed information the LED status indicators.
1)
After the camera has been booted completely,
press the G-Sensor calibration button once
(small red button to the left of the panic button).
There will be a beep and LED light blink to indicate the G-Sensor calibration has
registered.
2)
Press the Panic button once to ensure it’s working properly. The Blue LED should flash
rapidly to indicate event recording has begun.
3)
Give the provided keyset to the fleet owner/manager/administrator as well as a copy of
the installation report. If you do not have an installation report template, you can visit
http://install.smartwitness.com
and complete the installation form there.
