39
4. Uploading/ Downloading the Setting File
4-1. Upload
Ø
The device can be configured with more options using the PC Viewer.
- Using the PC Viewer, set up the configurations as needed and then save
the settings to an SD card (or USB memory stick). Refer to Chapter 10 for
instructions.
- Insert the SD card (or USB memory stick) into the main unit and press
both [FN] and [
∧
] together.
- While uploading, you will see a progress bar and hear a sequence of
three beeps until complete.
- When uploading is complete, you will hear two short beeps and the
progress bar will close automatically.
4-2. Download
Ø
The configuration can also be downloaded
- Insert a SD card (or USB memory stick) and press both [Fn] and [
∨
]
together.
- While downloading, you will hear a sequence of three beeps until
complete.
- When downloading is complete, you will hear two short beeps.
- When ejecting the SD card, press down on the [
∨
] key for two seconds
until you hear two beeps. Then press the SD card in gently until it
unclicks and let go. When the card pops out partially, pull it out.
- Four files have been downloaded:
“dvrid.ini,setting.ini,version.ini,system.log” and are stored in the
“dvr_config_down” folder under a folder “MAC Address”.
Summary of Contents for SVC400GPS-L
