75
10-2-3-4. G-Sensor/Speed
Values from the G-sensor, speed, and RPM can be used as triggers.
G-Sensor
When the G-sensor exceeds the pre-set values, the event will
be triggered
GPS speed
When the GPS speed exceeds the value input here, the event
will be triggered
Pulse Speed
When the GPS speed exceeds the value input here, the event
will be triggered
Video Loss
When any camera losses its video, an alarm will go off to call
attention.
System
Warning
OSD
Speed
Source
Choose the speed source “GPS or Pulse” to be displayed on the
monitor.
Record CH
- Select the cameras that you wish to record when the motion
sensor is triggered.
- For example, you can choose camera 1 and 2 to record when
motion is detected in camera 1.
- The Record CH boxes: “
▢▢▢▢▢▢▢▢
”are Channels 1 to 8 starting
from the left to the right.
- Only the channels that are checked in the Device Menu can be
selected.
AlmOut1, 2
- An output alarm, such as a siren, can be used.
- Select from “N/A (0), 1, 5, 10, 20, 30, 30, 50, 60, and
∞
seconds”.
LiveoutCH/
Duration
- If you have a monitor connected, a video output can be used.
- Select how you wish the display layout should be from “1 / 2 /
3 / 4 / 5 / 6 / 7 / 8 / 2
×
2-1 / 2
×
2-2 / 3
×
3”
* If multiple motions are detected the unitwill follow the Liveout
Priority setting. Refer to section 10-2-3-5.
Duration
Select how long you wish to display from “5, 10,20, 30, 30, 50,
60, and
∞
seconds”
Summary of Contents for SVC400GPS-L
