16
SVC400P/SVC800P - User Manual
While setting the DST, the former date must be older then the new date. If the two
dates are the same, the DST will be invalid.
A)
DATE/TIME
DATE FORMAT(US or Int’s):
Press
ENTER
to select different format (MM/DD/YYYY, DD/MM/YYYY,
YYYY-MM-DD)
TIME FORMAT:
12H or 24H, Press
ENTER
to select different format.
TIME SYNC SOURCE:
The system allow have the time synchronizing via by either “GPS” or “NTP”.
o
While selecting the “GPS”, the device must have GPS connection and its GPS signal must be in
an area with good reception. To set the sync time in this menu, (the unit will record the time
difference-GMT offset), the unit will synchronize with GPS time once.
o
While selecting the “NTP” (Network Time Protocol), the device must have network access
connection and assign the NTP IP location.
This process run at 6:30am local time while the
system have network connection.
TIME ZONE:
Please choose the correct time zone where the vehicle is located.
SYNC TIME:
This is the time when the unit will sync the system time every day. The method depends on
the setting on the TIME SYNC SOURCE option:
NTP SERVER IP:
Input the IP server does support NTP protocol, in order to allow the system can have
time synchronization through the network. [Example: "192.43.244.18", "129.6.15.28", "211.22.55.116",
"194.88.2.60"]
DST:
Daylight Saving Time. Only when it set on, the following option will available:
o
DST MODE:
There are two modes: Auto / Custom. Auto: Set according to the international DST,
(i.e.: valid only between 2AM on Second Sun in March and 2AM on First Sun in NOV)
Scroll to
SAVE
to confirm the changes
