Touch Input:
Power On the Device
The right temple is the master device that connects to the phone
and has a built-in mic. The left temple is the peer device that
connects to the master and gets audio from the master.
The touch start and end areas are shown below. With each swipe
of the touch area, you will hear the haptic sound of clicking
(in some modes, you will hear a ding sound instead of clicking).
Swipe Forward
Swipe Backward
Power On:
Swipe forward on the touch area of the right temple and the left
temple. If prompted to swipe again, please do so. Note that if the
device is powering on from an upside-down position, it will power
on with just a touch also.
The temples will boot up and announce that the device is
powering on. Both temples (master and peer) have to be
powered on individually. This operation is needed only when the
device is in a powered-off state.
During power on, there will be a 2-3 second delay in haptic click
sounds from the touch swipes.
Power Off:
If the glasses are placed in an upside-down position, they will
power off.
If a full power off is needed, swipe backward on the left temple.
When asked to confirm, swipe backward again on the left temple
to confirm the power off. The device will play “Power Off” and
then shutdown.
Getting Started
Summary of Contents for TITAN EYEX
Page 1: ...User Guide ...
