CLI
Management Guide
TigerAccess™ EE
340
SMC7824M/VSW
8.7.5
Accessing to Slave Switch from Master Switch
After configuring all stacking configurations, it is possible to configure and mange by ac-
cessing to Slave switch from Master switch.
To access to Slave switch from Master switch, use the following command in
Bridge Con-
figuration
mode.
Command Mode
Description
rcommand
NODE
Enable
Accesses to a slave switch.
NODE: node number
NODE means node ID from configuring stacking in Slave switch. If you input the above
command in Master switch, Telnet connected to Slave switch is displayed and it is possi-
ble to configure Slave switch using DSH command. If you use the exit command in Telnet,
the connection to Slave switch is down.
8.7.6 Sample
Configuration
Sample Configuration 1: Configuring Stacking
The following is a stacking configuration by designating SWITCH A as a master and
SWITCH B as a slave.
Switch A
Master Switch
Switch B
Slave Switch
Manages with the
same IP address
Step 1
Assign IP address in Interface configuration mode of Switch and enable interface using
“no shutdown” command. In order to enter into Interface configuration mode, you should
enter into Interface configuration mode of VLAN to register as a switch group for stacking.
The following is an example of configuring Interface of switch group as 1.
SWITCH_A#
configure terminal
SWITCH_A(config)#
interface
1
SWITCH_A(interface)#
ip address
192.168.10.1/16
SWITCH_A(interface)#
no shutdown
SWITCH_A(interface)#
If there are several switches, rest of them are managed by IP address of Master switch.
Therefore you don’t need to configure IP address in Slave switch.
i
Summary of Contents for 7724M/VSW - annexe 1
Page 1: ......
Page 385: ...CLI Management Guide TigerAccess EE 384 SMC7824M VSW ...
Page 387: ......
