1.
Intended Use
The Mirco Mist Lubricator has been designed for lubricating and cooling ball bearings, plain bearings, gears, chains
to prevent them from wearing an to reduce friction.
Unlike conventional oilers (oil fog oilers), it will produce very fine oil mist, thus making it possible to transfer lubricant
to pneumatic equipment at the further distance with no waste of lubricant.
2.
How To Install
1)
The lubricator should be installed with an arrow on the body pointing the air flow direction and the bowl
turned down. (The connection port with an arrow on it shows an inlet side)
2)
INSTALL a filter having a mesh of less than 10u to inlet pipe.
3.
How To Fill Oil
Remove the plug, and fill fresh oil through the hole.
Do not over-fill the oil beyond the upper limit indicated on the bowl.
4.
How To Adjust
1)
Adjusting amount of oil droplets.
Turning the oil feed adjusting screw counterclockwise will increase oil droplets an turning it clockwise will
decrease.
2)
Adjusting air flow rate.
Turning the air feed adjusting screw counterclockwise will increase air flow rate and turning it clockwise will
decrease.
5.
Trouble Shooting
1)
When no oil droplet it produced though air is lowing.
(a)
Wrong piping direction ….. Change direction.
(b)
Little or no oil in blow ….. Fill oil.
(c)
Loaded felt ….. Replace felt.
(d)
Blocked oil feed adjusting screw ….. Take out screw and clean it.
2)
When oil leaks out of feed adjusting screw.
(a)
Excessively opened screw ….. Close a little.
(b)
Damaged needle guide “O” ring 23 ….. Replace “O” ring.
6. Caution
1)
Use fresh, clean oil.
2)
In replenishing oil, care should be paid lest dust should get in oil.
3)
Check amount of oil droplets once a day.
7. Specifications
Refer table
8.
Float Switch
1)
This Float Switch is used in level control system to make or break an electrical circuit through a
placement of the float.
Light weight and compact design have made installation and maintenance easier.
2) Specifications
Refer
table
3) Features
a)
Easy
installation
b)
Low price and reliable operation
c)
Compact and light weight
d)
Independent
contacts
e)
Easy
maintenance
Summary of Contents for AL430-1 Series
Page 4: ......
