Chapter 4: Specifications
Product Multi-counter
Mounting
Surface mount (with DIN rail or set screws)
Operation Addition and subtraction
Mode
Operation mode, Preset data setting mode, Function setting mode
Reset
External reset terminal
Indication
LCD (with back-light)
Digits 6
digits
Memory Backup
{medium}
Set values (Constantly hold), counts (hold/ non-hold switching)
{E
2
ROM (alarm indication at approx. 800,000 data writings)}
Input signal
Count input, control signal input (reset, hold, bank selection)
Count Input
No-voltage input
Pulse signal input
A/B quadrature input, UP/ DOWN individual pulse input (Note 1)
Counting speed
100 kHz (Note 2)
Control signal input
"For connecting COM terminal to 12VDC or 24VDC"
Conduction between each input terminal and GND terminal.
"For connecting COM terminal to GND terminal"
Conduction between each input terminal and 12VDC or 24VDC terminal.
power supply for sensor
12VDC
±
10%, 60 mA
Preset output form
Compare, hold, one-shot (fixed at 100 ms)
Output method
Individual 5 points output, binary code output
Output time lag
5 ms or less (in normal output)/
60ms or less (in binary output)
Communication RS-232C
Proof voltage
Between case and AC line: 1500 VAC, 1 minute
Between case and signal earth: 500 VAC, 1 minute
Insulation resistance
Between case and AC line: 500 VDC, 50M
Ω
or more
Ambient temperature
0
℃
to + 50
℃
(No freezing)
Ambient humidity
35% to 85%RH (no dew condensation)
Noise resistance
Square wave noise by noise simulator (pulse width: 1
μ
s)
Between power terminals:
±
2000V, input line:
±
600V
Vibration proof
Durable to 10 Hz to 55 Hz and amplitude of 0.75 mm in X, Y and Z directions
for 2 hours each.
Impact resistance
Durable to 10 G in X, Y and Z directions for three times each.
Weight
Approx. 350 g
CEU5
*-* (Without "B")
CEU5
*
B
-*
Output signal
Preset output , cylinder stop output
Preset output , cylinder stop output ,
BCD output
CEU5
*-* (Without "P")
CEU5P
*-*
Output transistor type
NPN open collector
(Max.30VDC,50mA)
PNP open collector
(Max.30VDC,50mA)
CEU5
**
CEU5
**-
D
Power voltage
100VAC to 240VAC (
±
10%)
24VDC (
±
10%)
Power consumption
20VA or less
10W or less
Note 1: Pulse signals can be counted by CEU5 should meet “Input waveform requirements” in the next
page.
Note 2: Counting speed of 100 kHz is provided when “Input waveform requirements” are met. When
signals are
damped due to long wires, taking countermeasures such as reducing the speed
is required.
－
８
－
