• After the introduction of the
EX510
series,
only the GW unit needs to be changed.
• In the past, all the part numbers of slave units were
needed to be changed by returning it to the
manufacturer and reordering (re-estimate, delivery
time) it.
No special tools are required for press-fitting the connectors for branch cable connections and the e-con
connectors for sensor connections.
The output unit adopts a spring type terminal box, eliminating the need to tighten any retaining screws.
• The SI unit which connects output devices such as
a solenoid valve has a compact design, compared
with a existing model. (Compactness: volume ratio
more than 60%)
60.8
30
64
Existing model (Series
EX120
)
Series
EX510
70
19.6
31
No need to strip the wire
Only pliers are required for clamping.
Branch connector
e-con connector
Lead wire
Flat head screwdriver
Torque control, crimping work is
unnecessary.
Screwless construction. No tightening
of retaining screws required.
Can flexibly change to Field Bus.
Feature
Compact SI unit
Feature
Adoption of connectors which do not require any special tools for installation
Feature
2127
EX12
EX140
EX180
EX260
EX250
EX600
EX500
EX510
PCA
EX
EX510