19
18
Display/ Switch Setting (continued)
Address setting (switch No.1 to 7)
All of the settings when shipped from plant are turned OFF and
the address is set 0. Make sure to set the station number in the
range of 0 to 125.
10
9
8
7
6
5
4
3
2
1
2
4
1
8
16
32
64
ON
SW1
OFF
ON
Address
HOLD/CLR
HW/SW
UNIT STATUS
Switch setting
Make sure that switch setting is performed with power supply turned off.
Open the cover, and set DIP switch with a small flat blade
screwdriver, etc.
64 (No.1)
1
Address
2
3
4
:
24
25
:
125
126
32 (No.2) 16 (No.3) 8 (No.4) 4 (No.5) 2 (No.6)
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
ON
OFF
:
:
:
:
:
:
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
OFF
OFF
:
:
:
:
:
:
ON
ON
ON
ON
ON
OFF
ON
ON
ON
ON
ON
ON
1 (No.7)
ON
OFF
ON
OFF
:
OFF
ON
:
ON
OFF
∗
: If the address setting is turned on, an input setting for PLC is required.
Refer to "Operation Manual" for detail.
HOLD/CLR
CLR
Function
Output is cleared when a communication error
occurs.
HOLD
Output is held when a communication error
occurs.
No.9
OFF
ON
Mode
HW
Function
Set Address with SW1 to 7.
SW
Address are set by network.
The setting when shipped from plant is 126.
∗
: SW1 to 7 are ignored.
No.10
OFF
ON
∗
: HOLD/CLR setting is made available per one point by parameter
setting. Refer to "Operation Manual" for detail.
0
OFF
OFF
OFF
OFF
OFF
OFF
OFF
∗
: Setting of the address 126 and 127 are invalid.
UNIT STATUS setting (switch No.8)
The setting is as follows.
The settings when shipped from plant is turned OFF, GW status
information is not sent to master side as an input data.
UNIT STATUS
OFF
Function
GW status information isn't sent to master
side as an input data.
ON
GW status information is sent to master side
as an input data.
No.8
OFF
ON
127
ON
ON
ON
ON
ON
ON
ON
Setting of Address, UNIT STATUS, HOLD/CLR and
HW/SW mode (SW1)
Setting of Address, UNIT STATUS, HOLD/CLR and HW/SW
mode are done with SW1.
HOLD/CLR setting (switch No.9)
The setting is as follows.
The setting when shipped from plant is turned OFF, set to CLR.
HW/SW mode setting (switch No.10)
The setting is as follows.
The setting when shipped from plant is turned OFF, set to HW
mode.