HRX-OM-O021
Chapter 5 Display and setting of various functions
HRS Series
5.18
Communication function
5-67
50.
Select contact output signal 1 selected alarm from the table below with [
▲
] key or [
▼
]
key, and confirm by pressing “SEL”.
Table 5.18-26
List of set value
Set value
Explanation
Initial value
(Default setting)
Setting/checking are not available unless the
function setting of digial output 1 is selected
alarm status signal.
to
Sets selection alarm.
Set range is AL.01 to AL.36.
Contact output signal 2 function Setting
and checking
51.
Press the [SEL] key once.
The set screen of contact output signal 2 functions are displayed on the digital display.
PV
SV
52.
Select contact output signal 2 function from the table below with [
▲
] key or [
▼
] key, and
confirm by pressing “SEL”.
Table 5.18-27
List of set value
Set value
Explanation
Initial value
(Default setting)
Without output signal
Signal of operating status is output
Signal of remote status is output
○
Signal for completion of preparation (TEMP
READY)
Signal for the status of the operation stop alarm
is output
Signal for the status of the operation continue
alarm is output
Signal for the alarm status is output
Signal for selected alarm status is output
Signal for Run timer set status is output
Signal for Stop timer set status is output
Signal for the recovery from power failure is
output
Signal for anti-freezing setting is output
Pass through signal of contact input signal 1
Pass through signal of contact input signal 2
Signal output during automatic fluid filling
