HRX-OM-S010
Chapter 2 Contact input/output communication
2.4
Setting and checking
HRS100/150 Series
2-14
32.
Select contact output 3 function from the table below with [
▲] key or [▼] key, and confirm
by pressing “SEL”.
Table 2.4-17
List of set values
Set values
Explanation
Initial value
(Default setting)
Without signal output
Operation status signal output
Remote status signal output
Ready completion (TEMP READY) signal output
Operation stop alarm signal output
Operation continuation alarm signal output
Alarm status signal output
○
Selected alarm status signal output
Operation start timer setting status signal output
Operation stop timer setting status signal output
Recovery from power failure setting status signal output
Anti-freezing setting status signal output
Contact input signal 1 pass through signal output
Contact input signal 2 pass through signal output
Warming up function setting status output
Anti-snow coverage function setting status output
1
1: Anti-snow coverage function cannot be set on the products of the cooling method
‘-W’.
Contact output 3 operation
Setting and checking
33.
Press the [SEL] key once.
The set screen of contact output 3 operation is displayed on the digital display.
34.
Select contact output 3 operation from the table below with [
▲] key or [▼] key, and confirm
by
pressing “SEL”.
Table 2.4-18
List of set values
Set values
Explanation
Initial value
(Default setting)
N.O type
N.C type
○
PV
SV
