HRX-OM-R026
Chapter 3 Transport and Setting Up
HRSH Series
3.1
Transport
3-1
Chapter 3 Transport and Setting Up
3.1 Transport
The product is heavy and has potential danger at transport. Also, to prevent
damage and breakage of the product, be sure to follow these instructions for
transport.
When the product is carried by using a forklift, make sure that the
fork does not damage the cover panel, piping port, or caster.
Do not manipulate the fork in the range outside the label at the
bottom of the side surface of the product.
Drain the residual fluid from the piping as much as possible to
prevent any spillage.
Only persons who have sufficient knowledge and experience
about the product and system are allowed to transport and set up
the product.
Especially pay attention to personal safety.
Never lay the product on its side.
The compressor oil will leak in to the refrigerant piping, which may
cause early failure of the compressor.
When moving the product by a folklift, insert the fork into the right
psitions refering to 3.1.1
Moving by forklift.
Moving by forklift should be done by persons who have the
licenses.
