Doc. no.IZ
*
-OMX0012
13
4-3.
Mode setting switch
- Blow or trigger can be selected by switching the mode setting switch.
- Open the slide cover over the mode setting switch and rotate the dial to the set number (No.0 to 9)
Note)
while referring to the table below.
- Be sure to close the slide cover after the settings.
Note) Default setting: Setting No.0
Table for mode setting switch
Setting
No.
Blow setting
Trigger setting
0
Continuous blow
Trigger linked
1
Trigger locked
2
OFF
timer
3 sec
3
5 sec
4
7 sec
5
Pulse blow
Trigger linked
6
Trigger locked
7
OFF
timer
3 sec
8
5 sec
9
7 sec
Blow setting
- Continuous blow (Set No.0 to No.4)
Blows ionized air continuously.
- Pulse blow (Set No.5 to No.9)
Blows ionized air intermittently.
Pulse frequency: 5 Hz
Trigger setting
Trigger ON is enabled by inputting either the main unit trigger or external switch signal.
- Trigger linked (Set No.0 and No.5)
Trigger ON/OFF and blow ON/OFF are linked.
- Trigger locked (Set No.1 and No.6)
Blow ON is maintained when trigger operation
is ON
When the trigger operation is ON again, the
blow is OFF.
- OFF timer (Set No.2 to No.4, No.7 to No.9)
Blow ON is maintained when trigger operation
is ON
Blow is automatically OFF after the timer set
time has elapsed.
Timer set time: 3 sec, 5 sec, 7 sec
O
F
F
t
im
e
r
Trigger
ON
OFF
Air blow
ON
OFF
Timer set time (3 sec., 5 sec.,7 sec.)
Continuous blow or Pulse blow
Trigger
ON
OFF
Air blow
ON
OFF
T
ri
g
g
e
r
lo
c
k
e
d
Continuous blow or Pulse blow
T
ri
g
g
e
r
li
n
k
e
d
Trigger
ON
OFF
Air blow
ON
OFF
Continuous blow or Pulse blow
Slide
Mode setting switch
Continuous blow
Pulse blow
