v
SMCD3GNV5 Administrator Manual
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be labeled
in a visible area with the following: “Contains TX FCC ID: JI5-RT539222SB24”.
Manual Information That Must be Included
This module must be properly installed in an approved device to function properly.Installation should be
performed only at the factory or by a qualified service technician.The module should be inserted into the
mini-PCIE connector. Once installed into the mini-PCIE card slot, carefully attach the Wi-Fi antennas
to the connectors on the card.
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user manual of the end product which integrates this module.
The user manual for OEM integrators must include the following information in a prominent location
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used
for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
For all the model ship to USA market, OEM integrator shall limit the accessible channel to US channel
1 -11 only during the manufacturing process by special firmware setting which is not available to the
end user.
