- 40 -
5. Manual Operation tab
(1) Manual operation
The manual operation of the air gripper can be checked.
By tapping the OPEN or CLOSE button, it is possible to perform an opening or closing action of the
gripper.
(2) Monitor sensor signal
It is possible to confirm whether the Open position or Close position auto switch reacts.
5-4. Air supply
！
Warning
1. Please contact SMC when using the product in applications other than with compressed air.
2. Compressed air containing a large amount of drainage can cause the malfunction of pneumatic
equipment. An air dryer or water separator should be installed upstream from filters.
3. If condensation in the drain bowl is not emptied on a regular basis, the bowl will overflow and allow
the condensation to enter the compressed air lines. This causes the malfunction of pneumatic
equipment. If the drain bowl is difficult to check and remove, the installation of a drain bowl with an
auto drain option is recommended.
4) Use clean air.
Do not use compressed air that contains chemicals, synthetic oils including organic solvents, salt or
corrosive gases, etc., as it can cause damage or malfunction of equipment.
For detailed information regarding the quality of the compressed air described above, refer to
SMC's "Air Cleaning Systems".
！
Caution
1. When dry air is used as the fluid, degradation of the lubrication properties inside the equipment
may occur, resulting in reduced reliability (or reduced service life) of the equipment. Please
consult with SMC.
2. Install air filters.
Install an air filter at the upstream side of valve. Select an air filter with a filtratio
n degree of 5μm
or finer.
3. Install an aftercooler, air dryer or drain catch before the filter and take appropriate measures.
Compressed air that contains excessive foreign material may cause malfunction of valves and
other pneumatic equipment.
Therefore, take appropriate measures to ensure air quality, such as by providing an aftercooler, air
dryer or water separator.
Summary of Contents for JMHZ2-16D-X7400B-DTB-N
