64
2.
Click
GO
to see the Update page.
Table 6.6.1 SIP Trunk Configuration Settings
Field Description
Trunk Identifier
A unique number consisting of digits only. Usually give
the phone number issued by the ITSP for consistency.
Description
Arbitrary description information.
Dynamic Peer
Select if the trunk is a passive trunk which means the
registration will be from a dynamic remote peer. Typical
application is to accept registration from an IPPBX at a
remote site with dynamic IP address. Once the remote
IPPBX registers, calls from local to remote can be
made reversely over the trunk.
SIP Proxy IP
SIP Proxy Port
Specify IP address (or fully qualified domain name) and
UDP port of the remote SIP proxy, which usually refer
to the SIP server on the ITSP side.
Auth. Name
Specify the name for authentication if different to the
Trunk Identifier
.
Auth. Password
Give the password used for authentication on the
remote SIP proxy or registrar. Usually this is given by
the ITSP.
Registration Required
Select if registration to a registrar is required to activate
the trunk. This is true for a remote IPPBX or an ITSP
account, however, may be not required in case of a SIP
gateway.
SIP Registrar IP
SIP Registrar Port
Specify IP address (or fully qualified domain name) and
UDP port of the remote SIP registrar, which usually
refer to the SIP server on the ITSP side (same as
proxy).
DID by Privilege
Select to configure
DID Prefix
and
DID Stripping
to
have the incoming calls directed to the trunk.
DID of Extension
When enabled DID, clicks an extension in the list to be
an unconditional destination for incoming calls to this
trunk. Or click
By Number
and then enter
configurations in
DID Prefix
and
DID Stripping
to have
the incoming calls directed to the corresponding
extension derived by number manipulation. The SIP
Summary of Contents for PBX10 FICHE
Page 1: ...SMCPBX10 TigerVoIP IP PBX Telephony System USER GUIDE TM...
Page 2: ......
Page 132: ...SMCPBX10...
