Cleaning and maintenance
67
EN
Setting the programmed Vapor Clean
cycle
It is possible to program the Vapor Clean
cycle start time, like any cooking function.
1. After selecting the Vapor Clean special
function, press the control knob. The
display shows the current time and the
symbol comes on.
2. Turn the control knob to set the time you
wish the Vapor Clean cycle to finish.
3. After a few seconds, the
and
symbols remain lit steadily and the
appliance waits for the set start time in
order to start the cleaning cycle.
End of the Vapor Clean cycle
1. Open the door and wipe away the less
persistent dirt with a microfibre cloth.
2. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
3. In case of grease residues use specific
oven cleaning products.
4. Remove any remaining water from inside
the oven.
For greater hygiene and to avoid food
being affected by any smell, we
recommend that the oven is dried using a
fan-assisted function at 160 °C for
approximately 10 minutes.
4.5 Pyrolytic (on some models only)
Preliminary operations
Before starting the pyrolytic cycle:
• Clean the internal glass pane following
the usual cleaning instructions.
• For very stubborn encrustations spray an
oven cleaning product onto the glass
(read the warnings on the product);
leave for 60 minutes, then rinse and dry
the glass using kitchen roll or a microfibre
cloth.
We recommend wearing rubber
gloves for these operations.
For easier manual cleaning of
parts that are difficult to reach, we
recommend removing the door.
Pyrolytic is an automatic high-
temperature cleaning procedure
which causes dirt to dissolve. This
process makes it possible to clean
the inside of the oven very easily.
Improper use
Risk of damage to surfaces
• Remove any large amounts of food
residues or spills from previous cooking
operations from the inside of the oven.
• Switch off the burners or electric hot
plates of the hob installed above the
appliance.
Summary of Contents for A11XPY-9
Page 88: ......
