Instructions for the installer
34
4.2 Preparing the appliance for use
It is recommended to prepare the appliance for use with the help of another person.
- Remove the packaging.
- Lift up the appliance in order to remove the polystyrene base.
- Remove the adhesive tape.
- Remove all the systems for holding the shelves in place (Fig. 2 pos. 2). Remove all the adhesives
from the object holder shelves: they are only necessary for the transport of the appliance.
- NOTE: When the fridge compartment door is opened a small red-coloured packing component will
fall out: THIS IS ONLY NECESSARY FOR TRANSPORT.
- Dispose of the packaging materials appropriately.
- To ensure that the condenser cools properly, the top part of the fridge freezer must not be located too
close to the wall. To avoid this, the product is equipped with two plastic spacers (Fig. 2 pos. 1) which
must be mounted on the upper part of the condenser at the back of the appliance as shown in figure 2.
Fig. 2