Remote control
16
9. THE REMOTE CONTROL
(Fig. 9)
RED LED
STANDBY KEY
“CUTTINGS” KEY
HUMIDIFIER KEY
INTERNAL LIGHT KEY
CLOCK DISPLAY/SETTING KEY
VALUE DECREASE KEY
VALUE INCREASE KEY
9.1
Red led
This led switches on whenever any key is pressed to confirm that the signal has been sent to the control
panel.
9.2
Standby key
This key activates the appliance’s circuitry when it is in standby. When it is reconnected to the power
supply, or after a lengthy power shutdown, the Home Garden will start up with the settings it had when it
was switched off. In particular, when first switched on, the Home Garden will be in standby, as shown by
the display described in point
, page 15. To activate automatic operation, simply point the remote
control at the appliance and press the
key.
Once automatic operation has been activated, the appliance’s circuitry will run a check of the displays
and all control panel leds will light up.
Once this check has terminated, the system will ask you to select one of the 3 pre-set programs or the
manual setting program
. For selection of the right program and how to activate it, refer to "10.3
Selecting the programme".
Once the program has been selected, the appliance will prompt you to set the time. For instructions for
setting the time, see "9.6 Clock display/setting key".
The
key is also used for unlocking the Home Garden’s settings: Ten minutes after any button has
been pressed for the last time, the Home Garden enters the "lock" mode and a dot lights up on the
humidity display (see point
page 14). This is a precaution against misuse, accidental or in play, by
children, who may attempt to change the settings and thus affect the growth of the plants.
To unlock the settings, point the remote control at the Home Garden and hold this key down for a few
seconds until the point on the display disappears. It is now possible to use the other keys on the remote
control again.
