EN
3
Information on household detergents, additives and cleaning agents can
be found on the following website
www.cleanright.eu
.
WARNING
: the higher the spin speed, the higher will be the noise and
the lower the remaining moisture content. The lower the amount of residual
moisture at the end of the wash, the lower the energy consumption will be
during drying."
Safety instructions
This appliance is intended for domestic use and is compliant with Directives
72/23/EEC and 89/336/EEC (including Directives 92/31/EEC and
93/68/EEC) currently in force.
Read all the instructions in this manual carefully before installation and use.
Check that the drum assembly has been released before use (see instruc-
tions). Failure to release the drum assembly may cause damage to the
washing machine and the surrounding furniture or appliances during the
spin cycle.
This Instruction Manual is an integral part of the appliance: it must always
be kept intact with the appliance. Installation must be carried out by quali-
fied staff in compliance with the relevant regulations. The appliance is built
to provide the following functions: washing and drying of clothes or fabrics
stated to be suitable for machine washing by the producer on the relevant
label. All other uses are to be considered improper.
The manufacturer de-
clines all liability for uses other than those stated above.
The nameplate with the technical data, serial number and mark is in a visi-
ble position in the part in view after the door has been opened.
The name-
plate must never be removed.
The electrical and plumbing works required to install the appliance
must only be carried out by skilled staff.
The appliance must be connected to earth in compliance with electrical sys-
tem safety regulations.
The manufacturer declines all liability for direct
or indirect injury or damage deriving from a non-existent or defective
earth connection.
In the event that the appliance is not connected by means of a plug, an om-
nipolar circuit-breaker device with contact gap of at least 3 mm must be
provided.
The plug to be connected to the power supply lead and the relative socket
must be of the same type and comply with the relevant regulations. Check
that the mains voltage and frequency are the same as the values marked
on the nameplate. The use of adapters or junctions is not recommended.
Never disconnect the plug by pulling on the power supply lead.
The appliance is only disconnected from the electricity supply if the
plug has been removed from the socket or the electrical system mas-
ter switch has been turned off. The power plug must be accessible af-
ter the appliance has been installed.
The appliance must be installed using new sets of hoses (supplied with the
appliance). Old hose sets should not be reused.
Take care that the appliance is not standing on the power supply cable.