Smeg LBS 845, User Manual

4

5

Warnings

•  This product is designed for home 

use. 

•  Your washing machine is adjusted to 

230V. 

•  If the fuse in your house is less than 

16A  than have a certified electrician 

deploy an 16A fuse. 

•  In case of transformer or non-trans-

former use, grounding installation 

must be performed with a licensed 

electrician. Any use before grounding 

is not our responsibility. 

•  Never place your machine over a car-

pet covered floor. Otherwise electrical 

parts of your machine may overheat. 

This may cause malfunction of your 

machine. 

•  Make sure hot and cold taps are 

connected correctly. Otherwise your 

laundry may come out hot and torn . 

•  Please call certified service for a fail-

ure of electric plug / cable. 

•  Be careful about your water hoses are 

not old. Do not use old / torn water 

hoses. This may cause stain in your 

laundry .

•  At first use, washing must be per-

formed at Cotton 90°C program with-

out loading with laundry for getting 

your machine ready for washing. 

•  Performance of your washing ma-

chine depends on the quality of water 

and hygiene compound used. If low 

quality and unfitting cleaning material 

is used the stains will be fixed. Before 

washing your laundry with stain keep 

your attention on cleaning the laundry 

as explained in following pages. 

•  This is period of keeping spare parts 

for your machine to operate. Because 

of quality control procedures there 

might be little amount of water in your 

machine. This does not have any 

damage to your machine. 

•   Your machine is programmed for start-

ing operation again when electricity 

is off and on afterwards. You can 

not press On / Off button to cancel 

program. Machine will go on program 

when electricity is on. To CANCEL the 

program press >Start/Pause/Cancel<  

button for three seconds. (See. Can-

celling a program)

  If “Door” led on program progress 

display is blinking program selection 

knob is middle position. In this case 

turn the knob and adjust it again. If 

the warning continues call authorized 

service. 

•  After your machine starts operation, if 

Start/Pause/Cancel key starts blinking 

than door is not locked. Open and 

close the door again begin washing 

program again. 

•  If the “washing” led on the program 

progress display is blinking either 

there is no water or tap is off. Check 

your taps. Turn your machine off and 

on. If the problem persists unplug 

your machine, turn off tap water and 

call authorized service. 

•  If program is started and program 

selection can not be performed your 

machine might be in protection mode 

due to infrastructure problem (voltage, 

water pressure, etc.) Press and hold 

the > Start/Pause/Cancel < button for 

3 seconds in order to switch machine 

to factory settings. 

•  Most of the warnings resulting in call-

ing an authorized service are due to 

infrastructure problems. For this rea-

son applying to an Authorized Service 

is recommended. 

5