Cleaning and maintenance
43
EN
6. At the end of the
Vapor Clean
cycle,
appears on the display and
a buzzer will sound that can be
deactivated by opening the door or
pressing/turning one of the two knobs.
7. Turn the
Function knob
to
0
to exit
from the function.
Programmed Vapor Clean cycle
It is possible to program the
Vapor Clean
function start time, like all other cooking
functions.
1. After having selected the
Vapor Clean
function, turn the
Select knob
(the
End of cooking indicator light
on) to set the time at which you want the
Vapor Clean
function to end.
2. Wait 3 seconds before confirming the
settings.
The appliance waits until the set start time to
start the
Vapor Clean
function.
Vapor Clean End
1. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
2. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
3. In case of grease residues use specific
oven cleaning products.
4. Remove the residual water inside the
oven.
5. If fitted, replace the self-cleaning panels
and the rack/tray support frames.
For greater hygiene and to avoid foods
taking on unpleasant odours:
• We recommend drying the inside of the
oven with a fan assisted function at 160°C
for around 10 minutes.
• If self-cleaning panels are fitted, we
recommend that you dry the inside of the
oven with a simultaneous catalytic cycle
(see
“Regeneration of self-cleaning
panels (catalytic cycle) (on some
models only)”
We recommend wearing rubber
gloves for these operations.
We recommend removing the
door in order to make the manual
cleaning of the parts that are
difficult to reach easier.
