User instructions
To set the delay once the program has started
, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
•
press
the
START/PAUSE
button
(4)
for a few seconds, until the
PHASES/PROGRAM
lights
(8)
come on;
•
annul the program in progress (see relative section) and wait for the
cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press
the
START/PAUSE
button
(4)
to start the new program.
If the program you wish to carry out is different from the one
already in progress:
•
press
the
START/PAUSE
button
(4)
for a few seconds, until the
PHASES/PROGRAM
lights
(8)
come on;
•
change the program;
•
select the delay required;
•
press
the
START/PAUSE
button
(4)
to start the new program. The
dishwahser will pump out the water and restart with the delay set
and the new program.
