14
Instructions for the user
7.6.1
Cooking with preset temperature
After selection of the function required, the oven will start the cooking
procedure at the preset temperature and the symbol
will come on.
Cooking itself is preceeded by a preheating stage, which allows the oven
to heat to the cooking temperature more quickly. The
symbol flashes
on DSP2 to indicate that this stage is in progress. When the preheating
stage is over, the
symbol will remain constantly on and a buzzer will
sound to indicate that the food can be placed inside the oven.
On the pyrolithic models, the special defrosting and proving functions are together
in the same symbol
. Set the temperature to choose the function: thawing (30°C)
or proving (40°C). On the multifunction models, it is not possible to vary the
temperature in the defrosting and proving functions.
7.6.2
Changing the preset temperature
The temperature preset for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 in either direction to
increase or decrease the cooking temperature by 5 degrees at a time.
(
PT1 can also be held in the left or right position to increase or decrease
the setting more quickly
.)
7.6.3
Using the minute minder
Press PT1 once (either in the STAND-BY or ON mode). The display will
show the
figures (constantly on) and the
symbol (flashing). Turn
PT1 to set the minutes of cooking (from 00:01 to 04:00:00). A few seconds
after the required duration is set, the
symbol will stop flashing and stay
on constantly; the countdown will start from that moment. Now select the
cooking function required and wait for the buzzer to sound, indicating that
the cooking time is over.
Press PT1 once to switch off the buzzer; extended cooking time can be set
by turning PT1.
If the minute minder was set in STAND-BY mode, when the oven is activated in ON
mode (selection of a cooking operation), the counter is reset to zero.
Warning: the minute minder does not stop the cooking process. It only warns the
user that the preset number of minutes have passed. To switch the oven off, press
PT2.
Modifying the data set
After setting the countdown, press PT1 once. The
symbol starts
flashing; turn PT1 to change the set duration. A few seconds after the last
change, the
symbol will stop flashing, and the countdown will restart
from the new value.
