Problem
Possible cause
Solution
There is too much frost and
ice.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Refer to "Closing the door".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not wrap‐
ped properly.
Wrap the food products bet‐
ter.
Temperature is set incor‐
rectly.
Refer to "Operation" chap‐
ter.
The compressor does not
start immediately after
pressing the Super, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after
a period of time.
Temperature cannot be set.
The Super function is
switched on.
Switch off Super manually,
or wait until the function re‐
sets automatically to set the
temperature. Refer to "Su‐
per function"
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tempera‐
ture is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if neces‐
sary.
The Super function is
switched on.
Refer to "Super function".
There is no cold air circula‐
tion in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance.
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of
the door.
22
Summary of Contents for S3F0922P
Page 13: ...milieustation bij u in de buurt of neem contact op met de gemeente 13 ...
Page 50: ...50 ...
Page 51: ...51 ...
Page 52: ...211624086 A 402017 ...