Smeg SBS66 Series, User Manual Manual

14

Refrigerator Leveling & 

Door Adjustment 

(If needed)

The refrigerator must be level in order to maintain optimal 

performance and desirable front appearance.

(If the floor beneath the refrigerator is uneven, the freezer 

and refrigerator doors look unbalanced.)

In case freezer door is lower than 

refrigerator door...

Insert a screw driver (flat 

tip) into a groove of the left 

wheel (bottom of freezer) 

and turn it clockwise until the 

door is balanced. (Clockwise 

to raise freezer door, 

counterclockwise to lower.)

※

 If the freezer door is not balanced by step 1, then

      follow the next steps.

Open the doors, unscrew the 

front cover and remove, if it is 

attached.

       Insert a spanner (A part) into the hinge nut (1 part) and
       unscrew the nut by turning clockwise.

Insert a spanner (B part) into the hinge nut (2 part)
and turn clockwise to lower the door.

If the door is aligned, fasten the nut (1) tightly by turning 
counter-clockwise.

In case refrigerator door is lower than 

freezer door...

Insert a screw driver (flat tip) 

into a groove of the right wheel 

(bottom of refrigerator) and 

turn it clockwise until the door 

is balanced. (Clockwise to 

raise refrigerator door, 

counterclockwise to lower.)

※

 If the refrigerator door is not balanced by step 1, then 

     follow the next steps.

Insert a spanner (A part) into the hinge nut (1 part) and 

unscrew the nut by turning clockwise.

Insert a spanner (B part) into the hinge nut (2 part) and 

turn counter-clockwise to tighten the door.

If the door is aligned, fasten the nut (1) tightly by     

turning.

Front Cover

After installation and/or door leveling, fasten front cover with 

screws. (Remove the screws on the front bottom panel first. 

Click and screw the cover.)

Caution

●

The front of refrigerator needs to be just a little  

    higher than the back for easy door closing, but if 

    the wheel is raised too much for door balance, 

    i.e. the front of refrigerator is much higher than 

    the back, it can be difficult to open the door.

Water filter

1.  Remove the locking cap for 

intalling the filter.  

(The ice and water dispenser can 

also be used without a water filter, 

in which case the locking cap 

must be used. )

2. Carefully turn the filter clockwise.

3.  Change the filter at least every 

6months.

※

  A New filter can be obtained from 

aftersales service.

Caution

●

Wipe up with cloth if droplets fall when 

exchanging a filter.

1

1

2
3

2

4

3

4

5

ZY600-4(�).indd   14

2019-05-31   �� 4:17:12