Smeg SC166PZ, Instructions For Installation And Use Manual

Instructions for the user

Cooking start:

 as well as setting a cooking duration time, the user can 

also set the cooking start time (up to 12 hours after the current time). To 
set the cooking start/end time, proceed as follows. 

- 

Set the cooking duration time as described in the previous point. 

- 

Within 6/7 seconds after the last time the 

 or 

 keys are 

pressed, press the 

 key to set the cooking start time. The display 

will show the current time with the inside segments indicating the 

cooking end time illuminated. Use the 

 and 

 keys to set the 

cooking start time. 

- 

6/7 seconds after the last time a key is pressed, the display will 
show the current time and the cooking start and end times, indicated 
by the illuminated inside segments.  The segments on the display 
will be constantly on until the current time is the same as the 
cooking start time; as soon as the current time reaches the cooking 
start time set, all the inside segments will start to flash, indicating 
that the oven has started cooking. 

- 

When the end of the cooking time is reached, the timer will switch 
off the oven heating elements, the beeps will start and the numbers 
on the dial will flash. 

- 

To reset the entire program set, keep the central key 

pressed for 

1 or 2 seconds

:

 if cooking has already started the oven will have to 

be switched off by hand. 

- 

The image on the right shows an example of 
programming: the current time is 7.06 and 
cooking is programmed to start at 8 o'clock 
and finish at 9. 

- 

At 8 o'clock, the inside segments between 8 
and 9 will start to flash and the hour pointer will 
remain still. 

Caution: for the oven to start cooking after the programming procedure 
just described, the thermostat and function selector must be properly set 
on the temperature and function required. 
 

3.3.4

"DEMO" Function 

Models with analogue/digital programmer feature a "DEMO" function 
which deactivates the heating elements while leaving the other functions 

unchanged. To activate it, simply press the 

, 

, and 

 keys and 

keep them held down for 3-4 seconds. A confirmation buzzer will inform 
the user that the function is active. When the “DEMO” function is active, 
the number 6 on the clock flashes at regular intervals. To deactivate it, 
simply repeat the same procedure. 

45