15
Instructions for the user
For safety reasons, when setting automatic cooking the user must first
program a cooking duration and then set the cooking start time. It is not
possible to set the cooking start time only, without setting the cooking
duration.
After setting the duration, press PT1 once.
The
symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the
cooking start
time required to be set
.
A few seconds after the required duration is set, the
and
symbols
will stop flashing, and the oven will start to wait for the starting time set.
While waiting for the start time it is not possible to select another cooking
function. At the end, the word STOP will appear on DSP1, cooking will
stop and a buzzer will sound; press PT1 once to deactivate it. It is also
possible to select an additional cooking time semi-automatically by turning
PT1.
If you wish to continue cooking beyond the set time, press PT1 again. The oven will
restart normal operation with the temperature settings selected previously.
PT2 has to be pressed to switch the oven off completely.
Modifying the data set
Once automatic cooking has started, its duration can be changed.
When the
and
symbols are steady and cooking is in progress, or
the oven is in stand-by status waiting for cooking to start, press PT1 once.
The
symbol starts flashing and PT1 can be turned to change the set
duration.
Press PT1 again; the
symbol goes out, the
symbol will start to
flash, and the cooking start time will be displayed on DSP1. The cooking
start time can be increased or decreased by turning PT1.
A few seconds after the last change, the
and
symbols will appear
(in steady mode) on DSP1 and automatic cooking will restart with the new
settings.
Once cooking has been programmed, before it starts, the function or recipe symbol
will remain on, as will the symbols
,
.