10
Installation
IMPORTANT: Before installation read all the instructions and make sure that the voltage (V)
and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and
frequency in your home. The rating plate can be found behind the grease filters.
The manufacturer & supplier declines all responsibility in the event of the installer failing to
observe all the accident prevention regulations in force, which are necessary for normal use
and the regular operation of the electric system.
Electrical connection
Your rangehood is intended for fitting with a cord & plug for connection to 10A power
outlet.
The power cable must be connected to the terminals marked L (live) and N (neutral) in
the rangehood and fixed with a cable clamp.
The rangehood’s power cable must be fitted upstream from the electrical connection
using an omni-polar switch with a contact distance of at least 3mm.
WARNING: THIS APPLIANCE MUST BE EARTHED!
We recommend that the appliance is connected by a qualified electrician, who is registered
with the Electrical Workers Registration Board (EWRB) and who will comply with ALL
regulations. The wires in the mains lead are coloured in accordance with the following NZ
code:
Blue = Neutral, Brown = Live, Green/Yellow = Ground
If you can only find two wires in the cable (blue and brown), neither must be connected to
the Earth terminal.
As the colours of the wires in the appliance’s mains lead may not correspond with the
coloured markings identifying the terminals in your spur box, please proceed as follows:
The blue wire must be connected to the terminal marked “N” (neutral), or coloured
black.
The brown wire must be connected to the terminal marked “L”
(live), or coloured red.
The green/yellow wire must be connected to the terminal
marked “E” or “⏚”.
