Smeg SHIG910X, Instruction Manual

EN 

1

12 

Activated Charcoal Filter (Recirculation Version) 

•  This cannot be washed or regenerated, and must be changed when all the command LEDs 

start to flash, or at least once every 4 months.  

Activating the alarm signal 

•  In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at 

a later date. 

•  Press and hold the 

Delay 

button (

T4

) on the keypad for 

5 seconds

 and the following will be dis-

played: 

  •  Leds (L1-L2-L3) flash twice – Activated Charcoal Filter saturation alarm ACTIVATED. 
  •  Leds (L1-L2-L3) flash once – Activated Charcoal Filter saturation alarm DEACTI

 VATED. 

CHANGING THE ACTIVATED CHARCOAL FILTER 

Resetting the alarm signal

• Press button 

T1 

(see the paragraph on Use). 

Changing the Filter

•  Remove the Metal grease filters. 
•  Remove the saturated Activated Charcoal filter, as shown in 

the figure. 

•  Fit the new Filter, hooking it into place. 
•  Replace the Metal grease filters. 

Lighting 

LIGHT REPLACEMENT 

20 W halogen light. 

•  Remove the snap-on lamp cover by levering it from under the 

metal ring, supporting it with one hand. 

•  Remove the halogen lamp from the lamp holder by pulling 

gently. 

•  Replace the lamp with a new one of the same type, making 

sure that you insert the two pins properly into the housings on 
the lamp holder. 

•  Replace the snap-on lamp cover.