GB
21
11
The machine does not spin
The unbalanced load sensor has triggered because the washing is not
uniformly distributed inside the drum. If the washing is wet at the end of
the cycle, distribute it well inside the basket and repeat just the spin cycle.
12
Draining water from the
drum
In the event of a power failure or a fault in the appliance, the water inside
the drum can be drained as described in paragraph 6.3
13
The washing has not been
correctly spun
Large items have rolled up and are not uniformly distributed inside the
drum. Always wash large items together with small ones.
14
Residues of detergent on
the washing
Many phosphate-free detergents contain substances that are difficult to
dissolve in water.
Select the Rinse programme or brush the washing.
ERROR SIGNALS
In the event of a malfunction, the “End” programme phase LED starts flashing and the LED's located above the
options buttons light up to signal the fault.
The “End” LED flashes for about half a second and then goes off for the same amount of time before flashing
again. While the “End” LED flashes, the LED's located above the options button flash but do so more rapidly. To
determine the type of error, count the number of times the “End” LED flashes:
Number of times the “End” programme
phase LED flashes between two 15 second
intervals
Problem
5
The tub does not fill with water
Consult the troubleshooting table at point:
2
6
The water does not drain from the tub
Consult the troubleshooting table at points:
4
and
5
1
A leak has occurred and aquastop has triggered (only for
models fitted with this safety device)
For this type of error, turn off the water tap, remove the plug and
contact the Service Centre.
When the washing programme starts but the door has not been closed correctly, the “Start” and “Wash”
programme phase LED's start flashing alternatively at intervals of about half a second. This continues until the
door has been closed properly. The door open signal starts about 5 seconds after the washing programme
commences.
For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing
the water tap.
