Instructions for the user
16
12.EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals,
bulbs, and so on. The following instructions describe how to carry out these minor maintenance
operations.
Before any intervention, disconnect the power supply of the device.
12.1 Replacement of light bulb
Remove cover
A
by twisting anticlockwise, replace bulb
B
with another similar bulb (25 W). Refit the
cover
A
.
Only use oven bulbs (T 300°C).
12.2 Removing the door
Open the door completely and fit the pins (supplied) into
the holes from the inside. Close the door to an angle of
about 45°, lift it and remove it from its seat. To replace, fit
the hinges into the grooves provided, then lower the door
until it comes to rest and extract the pins. If the pins are
lost, two screwdrivers can also be used.
12.3 Oven door seal
To permit thorough cleaning of the oven, the seal may be removed. Before
removing the seal, take off the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown in the figure.
