GB
5.11 STARTING THE WASHING PROGRAMME
1. Before starting the selected programme, carefully close the door, open the water tap and add the
detergent and additive
2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the
cycle.
After starting, the display shows the time remaining until the end of the programme. The LED remains on
throughout the cycle.
Example
If delayed starting has been set (only for models featuring this option), the display visualises the time
remaining before the cycle starts. When delayed starting is set, the relative LED flashes on and off.
Example
5.12 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme may be interrupted at any time while it is running:
1. press “Start/Pause” for approximately 3 seconds: the display alternates between STOP (for 1 second)
and three horizontal lines (for 1 second) and the Start/Pause LED flashes.
The programme can also be stopped by turning the programme/temperature selection knob while the
cycle is running.
2. If you wish to change the washing programme, simply select the new programme by turning the
programme knob without pausing the machine first. The new washing cycle will be performed starting
from the beginning. If the tub is already full of water, the new programme will omit the filling phase.
3. To resume the cycle, press Start-Pause again.
5.13 END OF PROGRAMME
The washing programmes are automatically completed, the display shows END and the
“Time remaining” LED lights up.
1. Turn the programmes knob to OFF to switch off the machine.
2. Open the door.
3. Remove the washing from the drum.
4. Leave the door ajar in order to allow the inside of the washer dryer to dry.
5. Turn off the water tap.
If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub full
(spin speed 0), STOP appears on the display at the end of the washing programme, alternating with 0000 (spin
speed 0) and the spin LED lights up.
18
