EN
9
9
7.2
12a
7.2
12a
A
Inserting the Hood Canopy into the support surface from below
• The Hood is built ready for
front installation of the
Motor Unit.
• If the kitchen unit is arranged differently and the Motor Unit has to be
fitted on the back, the Plug already fitted on the back of the Hood
Canopy must be removed and replaced at the front, and the Cable with
cable raceway for connection of the Motor must also be repositioned
using the slot provided on each side (
A
).
Before proceeding, the Motor Unit must be fixed to the Hood Canopy
(see paragraph on Fixing the Motor Unit).
• Insert the Hood Canopy
from below into the
support worktop, drilled
as described above.
• With the aid of a
support, lift the Hood
Canopy until the front
comes out of the
Worktop.
• Insert the Brackets
7.2
, as indicated in the
figure, into the slots provided and fix them
with the screws
12a
provided.
• Centre the Hood Canopy with respect to the
Cooking Hob slot.
• Using the 2 screws
12c
provided, fix the
Hood Canopy to the worktop and remove
the supports.
Warning:
If the cooker top is made from a material that does not allow the screws
12c
to be inserted, use
a small amount of silicone to glue the Brackets
7.2
to the top and allow it to dry completely
before proceeding with installation.
Summary of Contents for T-9309-B
