Installation
11
EN
1.4 Wall attachment and anti-tip
device
Instructions for wall mounting (primary
system)
The anti-tip brackets are to be attached to
the rear wall as shown. The height of
bracket location from the floor is
determined after the range legs have been
adjusted to the installation height as shown
in the installation instructions and the range
has been leveled.
1. Level the range using the adjustable
leveling legs.
2. Fasten the plates supplied to the rear of
the appliance, aligning them with the slits
on the sides.
Warning
Electrical shock hazard
• Use extreme caution when drilling holes
into the wall or floor. There may be
concealed electrical wiring located
behind the wall or under the floor.
• Identify the location of the electrical
circuits that could be affected by the
installation of the anti-tip device, then turn
off power to these circuits.
• Failure to follow these instructions may
result in electrical shock or other
personal injury.
CAUTION
• Contact a qualified installer or
contractor to determine the
proper method for drilling holes
through the wall or floor material
(such as ceramic tile, hardwood,
etc.)
• Failure to follow these
instructions may result in damage
to wall or floor coverings.
