EN
6
2.2 POSITIONING AND LEVELLING
1. Place the appliance in the
chosen position.
2. Level the appliance carefully
in all directions with the aid of
a spirit level, adjusting the
height of the feet if necessary.
Once done, fix the feet in
place with the locknuts pro-
vided.
3. On appliances with
adjustable rear feet
, note that the rear of the appliance rests on skids and not on the feet.
Before inserting the appliance into its place between the kitchen units, check that the rear feet are screwed
fully in to prevent damage as the appliance is shifted into position.
Once the appliance is in position in the kitchen, the height of the rear feet has to be increased so that the ap-
pliance no longer stands on the skids. After adjusting the rear feet, level the appliance and fix the front feet at
the height required.
The water intake and drain hoses can be fitted pointing to the left or right for effective installation.
Warning!
•
This operation must be carried out with care to prevent the washing machine from vibrating, moving or
generating excessive noise during use.
•
If the appliance is installed on a carpeted floor, take care to ensure that the openings in the bottom of
the washing machine are not obstructed.
•
Also check that during operation the washing machine is not resting against walls, kitchen units, etc.
•
The appliance must not be installed behind a door with lock, a sliding door, or a door with hinge on the oppo-
site side.
