23
smithandnoble.com
24
800 .248 .8888
INSTALL SOLAR RECHARGE UNIT
Install Solar Recharge Unit
Tape Method
Cut the tape (part # MI051045) to fit
inside the white border as shown. Clean
the ends of the solar panel where the
tape will go with rubbing alcohol. When
dry, remove the release liner from one
side of the double sided tape and adhere
them to face of the panel. Make sure to
put the tape on the face (black side) of
the panel.
Clean the window surface with rubbing
alcohol. When dry, remove the release
liners and attach the solar panel to the
glass, pressing firmly to adhere.
Bracket Method
If using brackets, set the bott om groove
of the unit onto the bott om bracket hook.
The press the top of the unit unti l it snaps
into place.
If space is limited it may be easier to
att ach the brackets to the solar unit
before screwing the brackets in place.
Connect Solar Recharge Unit to
Motor
After the shade is installed, plug the solar
unit into the motor recharge port.
Use the cable ties included with the solar
panel to manage excess wire.
DOUBLE SIDED
TAPE
SOLAR PANEL RECHARGE UNIT
BRACKET
BOTTOM
BRACKET
HOOK
SOLAR
RECHARGE
UNIT
CONNECT SOLAR
UNIT HERE
TROUBLESHOOTING
PROBLEM
SOLUTION
The motor does not work
Recharge motor
The motor continues to run in one
direction
The limit setting was unsuccessful
and needs to be reset
The indicator light on the remote
does not shine or the remote-
controlling range becomes shorter
Replace the battery in the remote
(CR2430)
