8
Introduction
SET UP
(CONTINUED)
10. Check brake fluid in master cylinder by removing round plug on floorboard. Add brake fluid if necessary.
DOT 3.
11. Check hydraulic fluid. The hydraulic oil tank is on the right side. Fluid level should be 2 to 2
1
/
2
" (5 to
6.04cm) from the top of tank when cold.
12. Machine should be greased before starting, refer to Spray Star 1600H Parts/Service Manual for location.
13. Attach the Spray Boom and any other Optional Equipment to the Prime Mover, in accordance with
instructions in the Spray Star 1600HD Parts/Service Manual. The nozzles must be the correct distance
above the turf as described in Spraying Procedure of this manual. The spray boom must operate prop-
erly and the outer sections must break away safely if an object is struck by them, they must then return
to normal operation position.
14. Be sure to double check boom heights, nozzle spacing and displacement before spraying.
15. Fill tank with water and retighten the four bolts used to hold the tank in place.
16. Read operating instructions before starting.
Never allow pump to run dry! The valve on the suction side of the pump (between the pump
and tank) must be fully open whenever the pump is operated.
DAILY CHECKLIST
1. Check park brake adjustment. Adjust as required.
2. Check engine oil level. Add as needed. DO NOT OVERFILL.
3. Tire pressure should be 20 psi (1.4 bar) front and 18 psi (1.3 bar) rear maximum.
4. Inspect electrical system for loose connections or frayed wiring, including battery cables. Replace any
faulty equipment or tighten if loose.
5. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
6. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
7. Check brake fluid in master cylinder by removing round plug on floorboard. Add DOT 3 brake fluid if
necessary.
8. Check hydraulic fluid. The hydraulic power unit is located between the engine and the spray tank on the
left side. Remove breather plug and add SAE 10W-40 API Service SJ or higher motor oil if necessary.
Fluid level should be 2 to 2
1
/
2
" (5 to 6.04cm) from the top of tank when cold.
9. Inspect steering, throttle and shift linkages for good hookups and clear travel.
10. Check anti-vibration mounts on engine frame.
11. Check controls for smooth, proper working operation. Lubricate as needed.
SEAT ADJUSTMENT
Adjustment lever is located under the front of the seat on the right side. It allows the seat to be adjusted forward or back-
wards for the operator’s comfort. For further adjustment unbolt seat from seat panel, move to other set of holes and re-
bolt.
S
TEERING
Hydraulic steering. Before operating acquaint yourself with the steering.
Avoid sharp turns at high speeds, on slopes or unsafe terrain.
Summary of Contents for Spray star 1602HD
Page 42: ...Part 74 17 041503...
