Smith Performance Sprayers 190450, Use And Care Manual

Page 5

Steps To Cleaning Your Sprayer

*** To prevent clogging issues, after each use clean your sprayer.***
WATER BASED PRODUCTS

1. Release pressure in your sprayer via pressure relief valve. Do not undo handle without removing pressure.

2. Empty remaining chemical back into original filling container.

3. Fill sprayer with water, place pump back into tank, and tighten.

4. Aggressively shake the water in the tank to try and get residue off of the inside walls of the sprayer. Repeat  

    step if necessary, each time refilling with fresh water.

5. Pressurize the sprayer and spray water for 30-45 seconds into a disposable reservoir, then release pressure

    and remove the pump from the tank.

6. Tip and empty tank, then set tank upright. Hold wand and shut-off above the tank and depress the 

    shut-off. The liquid will drain into the tank, empty again.

7. Repeat the steps above as necessary.

8. Allow tank to air dry by leaving the pump outside of tank over night. 

OPERATING INSTRUCTIONS CONTINUED

Acetone Products

1. Release pressure in your sprayer via pressure relief valve.  Do not undo handle without removing pressure.

2. Empty remaining chemical back into original filling container.

3. Add approximately one pint of acetone, place pump back into tank, and tighten.

4. Shake the liquid in the tank to try and get the residue off of the inside walls of the sprayer.  Repeat step if

     necessary, each time refilling with fresh acetone.

5. Pressurize the sprayer and spray the acetone into an empty acetone can, then release the pressure and

     remove the pump from the tank.

6. Tip the tank and empty any remaining acetone into the acetone can, then set the tank upright.  Hold the

    wand and shut-off above the tank and depress the shut-off.  The liquid will drain into the tank, tip and

    empty the tank once again.

7. Repeat the steps above as necessary.

8. Allow the tank to air dry by leaving the pump outside the tank overnight.

Sprayer Storage

1. Sprayer tank should be hung upside down, with the pump removed.

2. Do not store or leave any solution in the tank after use.

3. Store in a warm, dry location out of direct sunlight.

4. Keep the sprayer and all chemicals out of the reach of children.

MAINTENANCE

Pump Lubrication

Pump should be periodically oiled by applying 10 to 

12 drops of light silicone based oil down the pump 

rod through the opening in the pump cap as shown.

NOTE: Only a Silicone Based Oil should be used.