7
Service
SERVICE CHART
Before servicing or making adjustments to the machine, stop engine, set park break, block
wheels and remove key from ignition.
Follow all procedures and ONLY use parts prescribed by the manufacturer. Read the engine
manual before maintenance.
The suggested maintenance checklist is not offered as a replacement for the manufacturer’s engine manual but
as a supplement. You must adhere to the guidelines established by the manufacturer for warranty coverage. In
adverse conditions such as dirt, mud or extreme temperatures, maintenance should be more frequent.
Clean more often under dusty conditions or when airborne debris is present , replace air cleaner parts, if very dirty.
Maintenance Service Interval
Maintenance Procedure
After the first 8 operating hours
Torque the wheel lug nuts. (64-74 ft/lb (87-100 Nm))
Change the engine oil filter.
Change the hydraulic filter.
After the first 20 operating hours
Change oil filter after first 20 and first 100 hours.
Before each use daily
Check the engine oil.
Check the hydraulic fluid level.
Check the tire pressure.
Check condition of hydraulic hoses and fittings.
Inspect and clean the machine.
Inspect cooling system.
Every 25 hours
Check the battery fluid level and cable connections.
Change oil when operating under heavy load or high
bi
t t
t
Every 50 hours
Change the engine oil and filter.
Every 100 hours
Check engine for leaks or loose parts.
Clean/Replace air cleaner.
Check tire pressure (5 psi).
Torque the wheel lug nuts. (64-74 ft/lb (87-100 Nm))
Grease Machine.
Check belt tension (where needed)
Every 250 hours
Change oil filter
Change hydraulic filter
Clean battery terminals
Every 400 hours or yearly
Lubricate machine
Check spark plugs
Visual inspection of machine and hydraulic hoses
Change oil.
Torque lug nuts.
Check battery terminals and electrolyte level.
Replace all filters.
Summary of Contents for 14270
