9
Maintenance
MAINTENANCE
WHEEL MOUNTING PROCEDURE
1. Set park brake on tow vehicle. Turn machine off and remove key.
2. Block one of the other wheels.
3. Loosen nuts slightly on wheel to be removed.
4. Jack up machine being careful not to damage underside of machine.
5. Remove nuts, remove wheel.
5. Place new wheel on hub lining up bolt holes.
6. Torque nuts to 64-74 ft/lb (87-100Nm) using a cross pattern. Retorque after first 10 hours and every 200
hours thereafter.
7. Lower machine to ground and remove blocks and jack.
TIRE PRESSURE
Caution must be used when inflating a low tire to recommended pressure. Over inflating can cause tires to
explode. Tires on the machine should be 20 psi (1.4 bar). Improper inflation will reduce tire life considerably.
SERVICE INTERVALS
Before each Use:
Lubricate all bearings on reel. Use No. 2 General Purpose Lithium Base Grease.
Check tow vehicle fluid levels.
Check fluid level in power unit. Use Universal Trans-Draulic Oil.
After Each Use:
Check all tines for any cracks or breakage..
Inspect hydraulic system for leaks or damage.
Check for loose or missing hardware.
After 10 hours:
Check tines for wear.
Retorque tine bolts to 80ft lbs.
Lubricate all grease fittings
After 50 hours:
Check wheel lug nuts torque to 64-74 ft/lb (87-100Nm).
Inspect tires - Check air pressure 20 psi
Retorque tine bolts to 80ft lbs.
After 125 hours:
Lubricate wheel bearings.
After 250 Hours:
Drain oil and fill power unit with approximately 1.25 gallons (4,73 l) Universal Trans-Draulic Oil.
Tire - Torque nuts to 64-74 ft/lb (87-100Nm) using a cross pattern.
Summary of Contents for AER 8 Aerifier
