Smithco AER 8 Aerifier, Parts & Service

4

Introduction

SETUP

The Aerifier arrives from

 Smithco 

banded on a pallet

.

1. Tow vehicle with 3-point hitch will be needed to transport the Aerifier.

2. If transport package is ordered the tongue hitch will need to be in-

stalled.

3. Remove tongue from pallet. Install the tongue and place jack in upright

position.

4. Crank the jack up so you can hook to tow vehicle.

5. Check the tire pressure.  20 psi (1.4 bar).

6. Check hydraulic fluid level in tank on tow vehicle or the electric/

hydraulic lift system if purchased.

7. Machine should be greased before starting. See Maintenance part of

manual.

8. Read operating instructions before starting.

9. If using electrical /hydraulic lift system, battery must be installed.

(Battery not included)

Use  Automotive type 24F-12 Volt

3-POINT HITCH ATTACHMENT

Excessive weight in the ballast tank on the 3-point hitch models will result in the loss of tow

vehicle stability and steering capability. If this occurs front counter balancing on the tow
vehicle or Aer8-001 Transport Frame Assembly must be installed. Maximum ballast weight is
200 lbs. per ft. of machine width.

1. The Aer-8 must be able to "float". The tractor must be equipped with

a "float" position on the lower link arms. The "float" position will allow
the tines to "float" upwards when an obstruction such as a rock is
contacted. This will reduce tine damage.

2. The  Aer-8 must be held in an upright and level position by the jack

legs prior to hitching to a tractor.

3. Back up the tractor until the lower arm ball joints are inside the frame

lift brackets.

4. Install the proper class link pins and quick pins to hold both arms to

the frame.

5. Attach the upper 3-point arm between the center tabs on the frame

and hold in place with the proper class link pin and lynch pin.

6. Once attached to the 3-point, adjust the lower arms so there is no

excessive sway.

Tines are sharp. Keep hands and feet away from reel.

7. Lift the Aer-8 hydraulically and then retract the jack legs.

8. Lower the  Aer-8 hydraulically to the ground and adjust the upper 3-point arm until

the Aer-8 column is perpendicular to the ground.

9. From the rear of the aerifier, add water to the ballast tank until the full depth of  the

tine penetration is reached. The amount of water used is determined by soil type,
moisture content and amount of compaction present.